Def 90 110 LH Front Galvanised Push Button Door (Galv Steel Skin) (S)

To fit all Defender models with push button doors between 1983-2006
We manufacture these ourselves in England spending a lot of time making these as accurate to the original as possible to ensure a great fit every time. The frame is steel which is hot dipped galvanised so will last a very long time indeed, in many cases these will probably outlast the rest of your Defender!

To finish this door off so it is the best you can get, the door frame is fitted with a zinc plated steel skin which not only increases the strength of the overall door massively compared with the original aluminium skin, but it is also a lot more corrosion resistant so you will not get the white bubbling corrosion you get with aluminium. Plus it is far more dent resistant.

Each component of the door is lovingly pressed and worked to create the final product that is our eyes is a work of art and designed to still be here in many years to come. We have always found it a shame to do nice work on a Defender, only to find out a standard spec door has already started to rust out within a couple of years, so you end up having to repeat the process all over again , hence why we make these ourselves and make the best possible door available.

In between the skin and the frame, we use marine bonding to stop the two surfaces rubbing together. This stops any drumming effect & makes the door feel a lot stronger & tighter all around.

Every threaded hole is clear of zinc and the hinges holes are drilled clear of zinc so this door is a straight swap over for your original part.

Please remember that hot dipped galvanising is an industrial process where the door frame is dipped into a molten bath of zinc. As a result there maybe some imperfections, i.e. excessive galv and in some instances where there was too much excessive galv, they have been flattened off before reaching mild steel and cold galv spray has been applied. There may be also some small areas where it is bare steel from where it has been hung on a wire or stuck to another item in the galvanising process.

Also of important note, you must not sand off any of the zinc coating on the skin before painting as this will remove the zinc coating and remove it corrosion resistance and lead to premature rusting. The zinc coating on the skin is perfectly smooth as it is applied electronically. Whoever paints the panel must be given the instructions to simply go over the skin and frame with Mordant solution / T wash which etches the zinc finish black and means the paint will properly adhere. You should then go over with an etch primer, then a high build primer and then finally your colour coats. Do not sand the skin at all before any paint is applied.