Series Anti Burst Door Conversion Kit Includes Handles Strikers Locks + Free Step Drill

Free Step Drill Bit Included.

Here is a fantastic kit that will convert your non anti burst Series doors to anti burst.

Included in the kit is:

O/S & N/S Anti burst handles

O/S & N/S strikers

2 x lock barrels including 3 matching key set

2 x lock hole surrounds

Step drill bit.

If you are tired of your doors bursting open at the worst possible moments this is the kit for you.

It takes minimal alterations to your door to change them over to anti burst.

Very simply, you need to drill a lock hole in your current doors (using a step drill which is included)

To figure out where to drill your lock hole in your door bottoms you can put grease or marker pen around the top of the circular lock hole shaft on the door handles & offer it up to the door bottom were it would fit. This will leave the circular grease mark on the back of the door skin which gives you the correct location to cut out.

The hole needs to be just over 2 cm in diameter although our lock hole surrounds allow for a bit either way.

This is a very good & high quality upgrade to your Series door bottoms & a nice little job to carry out that will make a great difference to your doors.